A Transmitter and a Captur Module Timer or Captur Module Pro….Two cameras and two matching Transmitters.If you want to use the Captur Remote Control in a studio and you want to use the system with: Using the Hahnel Captur Remote Control with two cameras and two sets of flashes In that case, you will need to re-match your Receivers with the Transmitter. If your flashes don’t fire and you have set up the Captur Remote Control system before, you might be in Digital Channel Matching mode, which could prevent some Receivers to react to your Transmitter. There is another mode that you will need to use when your setup gets more complicated. This means any Transmitter will activate any Receiver when triggered. However, if you started this tutorial with brand new Receivers, the Captur Remote Control system will be in Open Channel Matching mode. Now when you release your camera’s shutter, the flashes will fire. When you’re all set, turn on the Receivers, the flashes, the Transmitter and your camera. The next thing to do is mount your flashes on the Captur Remote Control Receivers. You can then mount the Transmitter on the adapter and use it as if there’s no adapter installed. If you own a Sony Alpha with the non-standard hotshoe, you will first need to buy an adapter that is capable of transferring all electrical signals to a standard hotshoe. For that to happen, you will need to mount the Captur Remote Control Transmitter on the flash shoe of your camera. To trigger photographic flashlights with the Captur Remote Control, you’ll need to set up the system so the camera can trigger the flashes to go off at the right moment. How to set up the Hahnel Captur Remote Control with one camera and two flashes The Transmitter’s LED will stop flashing. To stop taking shots or exposing, just full push again and the shutter will close. The button is now locked and you can lift your finger. To lock the Captur Remote Control’s Transmitter button for continuous shooting or long exposure, push the button down fully for 3 seconds until its LED flashes red. To prevent you having to hold down the Transmitter’s button for long periods, you can lock it. You can also use the Captur Remote Control to shoot continuously or have the shutter open for long exposure (bulb) photography. The Receiver’s LED will briefly turn red, the camera’s shutter will release and your photo will be taken. To release the shutter and take the photo, push the Transmitter button all the way down.The Transmitter’s LED will stop flashing and hold its green light steady on for as long as you hold down the button. To activate your camera’s autofocus, push the Transmitter’s large, grey release button lightly.Make sure the cable is firmly seated and pushed in fully. Connect the end of the cable that looks like a smaller version of a stereo mini jack to the Receiver’s cable port. Connect the included shutter cable to your camera’s remote control port (see your camera’s user guide for instructions).In practice, the Hahnel Captur Remote Control works perfectly if you stay within a 40 to 50 metre range, regardless of obstacles in-between the Transmitter and Receiver. The Captur Remote Control serves as a remote shutter control whereby you hold the Transmitter in your hand and connect the Receiver to your camera. Using the Captur Remote Control as a remote shutter control button I have successfully used the system with LumoPro LP160 and LP180 flashes. Manual flashes will work with the Captur Remote Control. The Hahnel Captur Remote Control only works with flashes set to manual mode. The Transmitter also doesn’t come with a cable port as the Receiver does. When you unpack the Hahnel Captur Remote Control you’ll notice that the Transmitter is the only device with a hotshoe. How to use the Captur Remote Control with two cameras and multiple flashes.How to set up the Hahnel Captur Remote Control for use with one camera and two photographic flashlights.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |